Project Name: EPC Gudang Urea Curah Cikampek Job Desk: 1. Steel Structure a). Inspection Fabrication - Erection & Installation until joint Inspection with Owner & Internal b). Make a Report from Joint Inspection & Progress Installation also documentation of photo 2. Piping Steam Chiller Dehum a). Inspection Fabrication - Erection & Installation until Joint Inspection with Owner & Internal b). Make a report from Joint Inspection & progress installation also documentation photo 3. All Mandatory Mechanical Equipment a). Inspection fabrication - erection & installation until joint inspection with the owner and internal b). Make a report from Joint Inspection & progress installation also documentation photo 4. Handle for Mechanical Pre-Commissioning, Commissioning & Mechanical Completion. 5. Administration Report/PPT.

Project Name: RDMP Project Balikpapan Job Desc: 1. PREPARATION OF TEST PACKAGE a. Provide documents related to the test such as marked-up piping layout, P&ID, isometric, high-low points for venting and draining, etc. b. Providing test procedures, testing methods, and HSE requirements. c. Developing System and Subsystem for Testing. d. Provide Instructions to verify the Satisfactory Test Result e. Provide instructions for the restoration of the system ex. draining instructions, removing temporary supports, and installation of equipment/instruments excluded from the test. f. Indicate in the drawing location of blinds, fill point, drain point locations, valve (open or close), vents at high points & drains at low points, etc. 2. TESTING IMPLEMENTATION • Complete the Test Instructions • Conduct Pre-test Inspection/Sign-off Release • Perform the testing in accordance with the test instruction requirements. 3. PUNCHLIST a. Provide feedback to design engineers on customer problems or needs. b. Inspect Piping to determine that installations are completed. c. Provide Punchlist Report d. Assist Construction and QC departments to work in accordance with the order of priority. 4. DRAWING REVISION a. Provide As built drawing and Field Change Request (FCR) to Main Contractor including Cutting Spool (Using H-Spool Software and AutoCAD)

Position: Mechanical Engineering Project Name: Project Mechanical and Piping Works Pulp Dryer FL3B RAPP. Job Desk : 1. Assuring all documents for construction needs are adequate and in the last update status. 2. Contributing technical expertise to project drawings and designs by implementing Intern-Discipline Checking among mechanical, civil, piping, and other disciplines through the 3D models on Navis Work Management. 3. Initiating coordination with owners, vendors, and contractors regarding technical issues in the field such as interfacing the scope of work between parties, design changes, and finding solutions as part of problem-solving. 4. Make a report to the Client about problems that occur during construction such as pipe clashing, inaccurate foundation elevation, etc as a result of an error in the drawing or design provided by the client in order to implement the change order procedure. 5. Conduct joint inspections of civil works that have been carried out before being handed over to the mechanical, piping, and other disciplinary teams for further work processing. 6. Assure readiness of material and equipment for construction purposes by providing material requisition, material Take off (MTO), and bill of material. 7. Provide modification drawing for any design changes on-site and its proposal of changes. 8. Monitoring equipment check-out, equipment punch list, and punch list report until commissioning. 9. Regularly controlling, reporting, and documenting the progress of mechanical work on a daily, weekly, and monthly based.

Project Name: Island Berth and SPL Development Project at LPG Terminal Balongan. Internship Topic Report: Evaluation of Pile Joint Work on Land and Sea from the Cost, Quality, and Time Side on The Island Berth and SPL Construction Project at the Balongan LPG Terminal. Job Desc: 1. Calculate, process and analyze data 2. Make reports and recommendations on the results of data analysis 3. Provide induction on safety and welding procedures